Mitsubishi Evolution
JDM Rear Bumper Conversion

Evo-JDM-rear-bumper-install-014

Evo-JDM-rear-bumper-install-015

Jumping back inside the trunk area, open the access panels and there you’ll find two bolts that hold the side of the bumper in place. Remove them.

Evo-JDM-rear-bumper-install-018

Evo-JDM-rear-bumper-install-017

There’s also a bolt holding the bumper to the plastic fender well that needs to come out.

Evo-JDM-rear-bumper-install-019

There’s also another bolt that secures the bumper to the fender arch.

Evo-JDM-rear-bumper-install-021

This one will be tricky to see. You have to lay down underneath the car and look directly at the center of the inside of the bumper and you’ll find this tab. Pop it out.

Evo-JDM-rear-bumper-install-024

Evo-JDM-rear-bumper-install-025

Now we can remove the clips and bolts that were hidden behind the tail lights. I left these for last because I didn’t want the bumper falling off with the other points secured and potentially damaging the metal retainer under the skin of the bumper.

Evo-JDM-rear-bumper-install-028

Evo-JDM-rear-bumper-install-027

Evo-JDM-rear-bumper-install-029

There are just four nuts left holding the bumper in place. Remove them.

Leave a Reply

1 Comment on "Mitsubishi Evolution
JDM Rear Bumper Conversion"

Notify of
avatar
Sort by:   newest | oldest | most voted
Streetmachince1984
Guest

Heck yeah. Very good info. Pictures are great too.

wpDiscuz